|
·
A Terrific Time Saver!
The Hub-SharkŪ System lets you replace
the front wheel bearing on front wheel
drive vehicles without removing the steering
knuckle from the vehicle. You
can complete work on each wheel in about
20 minutes. The Hub-SharkŪ pulls
trapped rotors too!
·
The Hub-SharkŪ System offers an efficient
way
to complete what has been a time consuming
task. You just remove the wheel,
caliper, axle nut and steering knuckle
from the lower control arm. Then push
the half-shaft back through the hub. Mount
the Hub-SharkŪ puller with the
center screw through the hub and place
the hub HPA washer behind the hub, put
the Big Nut on behind the Hub-SharkŪ remover,
turn the center screw with an
impact wrench and off comes the hub on
the center screw.
·
The Hub-SharkŪ puller jaws push against the
steering knuckle, so the hub is pushed
out from the back by the HPA washer,
and the hub will bring the trapped rotor
with it.
·
The Hub-SharkŪ System comes packed in two
plastic
cases with a space for each component.
|
